Archive:Configure your Cyberlink Media Centre Remote on Linux
Introduction
Cyberlink Media Centre Remote Control is some £5 USB remote control. It looks like this:
On Linux (>=2.6.29)it is detected as some kind of keyboard/mouse combo. The device mostly generates keyboard presses, like "0", "1", "2", "XF86AudioPlay", "Enter", "Delete" and so on. But unfortunately not all buttons will work, like "Subtitle" or the 4 coloured buttons (DVD/Music/Pictures/Videos) - which will impair your experience with XBMC.
The solution here involves:
- Setting up Lirc and the remote as a devinput Lirc device
- Setting up a Lircmap.xml file
Credits go to MrLux's forum post [1]. I added a few correction as:
- Lirc config has a mistake because event id doesn't always match device id
- probably becose the post is kind of old Lircmap.xml was not complete
The config files here will get your remote going on XBMC 10.00 on Ubuntu Maveric 10.10.
Lirc setup
- Install Lirc.
sudo apt-get install lirc
- You will be asked which remote to setup. You can choose "hauppauge nova-t 500" and as device select whatever you get from this command:
`cat /proc/bus/input/devices | grep -A4 "TopSeed" | grep event | tail -n1 | sed 's/.*\(event[0-9]\+\).*/\/dev\/input\/\1/'`
This command is selecting the second input device (the one with mouse and keyboard) created by the kernel driver when you insert the USB receiver. It will look similar to:
/dev/input/event14